Anyone have AUTOSKETCH from autodesk?
Had someone ask to have a native file SKD converted to DXF. this is on Practical Machinist site. I trying to help them out.
it was killed off in 2008 by AD, check the forum for answers.
never hurts to try and see here because you guys know alot of s h i t!
if not no biggy, thanks all
lenny
AutoSketch from AD, convert to DXF
- AlexLachance
- Posts: 2174
- Joined: Thu Mar 11, 2021 8:14 am
- Location: Quebec
- x 2353
- x 2008
Re: AutoSketch from AD, convert to DXF
Perhaps you could have some luck sending them to the guy in this thread
https://forums.autodesk.com/t5/autosket ... 204#M13977
crosby_a@hotmail.com
https://forums.autodesk.com/t5/autosket ... 204#M13977
crosby_a@hotmail.com
Re: AutoSketch from AD, convert to DXF
i didAlexLachance wrote: ↑Wed Jul 17, 2024 10:22 am Perhaps you could have some luck sending them to the guy in this thread
https://forums.autodesk.com/t5/autosket ... 204#M13977
crosby_a@hotmail.com
- Frederick_Law
- Posts: 1944
- Joined: Mon Mar 08, 2021 1:09 pm
- Location: Toronto
- x 1634
- x 1466
- AlexLachance
- Posts: 2174
- Joined: Thu Mar 11, 2021 8:14 am
- Location: Quebec
- x 2353
- x 2008
Re: AutoSketch from AD, convert to DXF
I don't think Len has access to AutoSketchFrederick_Law wrote: ↑Wed Jul 17, 2024 10:35 am https://www.autodesk.com/support/techni ... ormat.html
- Frederick_Law
- Posts: 1944
- Joined: Mon Mar 08, 2021 1:09 pm
- Location: Toronto
- x 1634
- x 1466
Re: AutoSketch from AD, convert to DXF
Then it's done.
Re: AutoSketch from AD, convert to DXF
Copies of autosketch 10 are available on etsy for a reasonable price. (Assuming it is legit.)
-
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams
I may not have gone where I intended to go, but I think I have ended up where I needed to be. -Douglas Adams
Re: AutoSketch from AD, convert to DXF
no I don't have, was someone on Practical Machinist Forum, was hitting up here just in case, never know if you don't ask.
thanks to all I found the same stuff and forward it to the OP on PM, he doesn't use a computer, does drafting he was helping someone else, went south fast, thats what I get for teying to help
thanks to all I found the same stuff and forward it to the OP on PM, he doesn't use a computer, does drafting he was helping someone else, went south fast, thats what I get for teying to help