Grabbing the UI border (MotionManager)
Posted: Mon Nov 08, 2021 8:19 pm
Is there a reasonable way to deal with this? lol
CAD Forum
A place FOR CAD users BY CAD users
https://cadforum-net.dezignstuff.com/
Grabbing the UI border (MotionManager)
Page 1 of 1
Re: Grabbing the UI border (MotionManager)
Posted: Mon Nov 08, 2021 9:40 pm
Dont click until the cursor change?
SOLIDWORKS 2019
SOLIDWORKS 2019
Re: Grabbing the UI border (MotionManager)
Posted: Mon Nov 08, 2021 11:08 pm
But the problem is the cursor changing itself, it a super thin border.
Maybe is a Windows trouble? (SW 2021, Windows 10 Pro and 3840x2160 resolution)
Is it easy to change the cursor for you? I will check again in my laptop, but I think it's also bad
(The Display Tree is a little better, and there's a tab that makes it easy)
Maybe is a Windows trouble? (SW 2021, Windows 10 Pro and 3840x2160 resolution)
Is it easy to change the cursor for you? I will check again in my laptop, but I think it's also bad
(The Display Tree is a little better, and there's a tab that makes it easy)
Re: Grabbing the UI border (MotionManager)
Posted: Tue Nov 09, 2021 1:51 am
Might be a display issue? (I am using 1920x1080 resolution)Lucas wrote: ↑Mon Nov 08, 2021 11:08 pm But the problem is the cursor changing itself, it a super thin border.
Maybe is a Windows trouble? (SW 2021, Windows 10 Pro and 3840x2160 resolution)
Is it easy to change the cursor for you? I will check again in my laptop, but I think it's also bad
(The Display Tree is a little better, and there's a tab that makes it easy)
Quite easy for my cursor to change as long as i pointed it at the right place (on the line) but as you mention, the "margin"/area for the cursor to change seem to be relatively smaller compared to other border