Page 1 of 1
Assembly opens lightweight
Posted: Fri Feb 09, 2024 9:16 am
by TTevolve
In the last couple of week I have noticed when I open an assembly the part are opening lightweight. I know there is the setting under System options\assemblies where you can set the component threshold for opening lightweight, but I have it set to 1000 and the assemblies I am opening only have 30 to 40 parts in them.
Is there any other reason anyone can think of why parts would be opening lightweight?
Re: Assembly opens lightweight
Posted: Fri Feb 09, 2024 9:33 am
by AlexB
I think you'll want to check this section of the Performance options
- image.png (11.97 KiB) Viewed 845 times
Re: Assembly opens lightweight
Posted: Fri Feb 09, 2024 9:36 am
by AlexLachance
@AlexB nailed it. You can also check this out:
Re: Assembly opens lightweight
Posted: Fri Feb 09, 2024 9:43 am
by TTevolve
AlexB wrote: ↑Fri Feb 09, 2024 9:33 am
I think you'll want to check this section of the Performance options
image.png
It was this one, not sure how it got checked. Thanks