E: SOLDERSLEEVE TERMINATOR WITH LEAD & CABLE DUPLICATION
Posted: Tue Jul 06, 2021 6:39 am
Hello!
I am currently designing harnesses for aero industry. I have a schematic drawing and I have to make a 3D harness out of it. So first I made a line diagram where I used all elements (connectors, splices) successfully. But when I want to add cable shield terminators into the line diagram the problem comes. I cant find a way to make symbol with passing circuit. A cable that goes through terminator (CWT) should remain unchanged, only the one wire - that connects to the shield of the cable, should be added. In some cases this wire goes to the connector pin, in some to the splice. But I cant find any proper solution to make symbol with hyper passing circuit or something similar, so the main cable can remain unchanged. Cable core reservation also dont work.
I also tried to make automatic harness out of schematics, but CWTs dont connect properly - they dont connect at all.
Other question is, how can you associate the same cable in schematics to the same cable in single-line diagram? First two pictures have yellow highlighted the same cable in schematics and in single-line.
Other are pictures of the most simple part of harness for easier understanding. (in single line cwts are not yet added). In the last photo is cable shield terminator (CWT).
Main focus is to make accurate 3D model of harness with correct BOM.
Hope my two questions are clear enough, thanks!
I am currently designing harnesses for aero industry. I have a schematic drawing and I have to make a 3D harness out of it. So first I made a line diagram where I used all elements (connectors, splices) successfully. But when I want to add cable shield terminators into the line diagram the problem comes. I cant find a way to make symbol with passing circuit. A cable that goes through terminator (CWT) should remain unchanged, only the one wire - that connects to the shield of the cable, should be added. In some cases this wire goes to the connector pin, in some to the splice. But I cant find any proper solution to make symbol with hyper passing circuit or something similar, so the main cable can remain unchanged. Cable core reservation also dont work.
I also tried to make automatic harness out of schematics, but CWTs dont connect properly - they dont connect at all.
Other question is, how can you associate the same cable in schematics to the same cable in single-line diagram? First two pictures have yellow highlighted the same cable in schematics and in single-line.
Other are pictures of the most simple part of harness for easier understanding. (in single line cwts are not yet added). In the last photo is cable shield terminator (CWT).
Main focus is to make accurate 3D model of harness with correct BOM.
Hope my two questions are clear enough, thanks!
